Sourcing coltan from the DRC without inheriting conflict risk

Certification schemes alone are no longer enough. A practical guide to mine-level traceability and the OECD five steps for tantalum buyers.

  • Coltan
  • 9 min read
  • CRP Africa Research Desk

Coltan — the ore from which tantalum is refined — sits inside every smartphone, laptop and many aerospace alloys. The DRC is one of the world’s most important sources. It is also where the link between minerals and armed conflict has been documented for two decades. For buyers, the question is not whether to source from the DRC, but how to do it in a way that holds up to scrutiny.

The rules buyers already operate under

  • EU Conflict Minerals Regulation — since 1 January 2021, EU importers of tin, tantalum, tungsten and gold (3TG) above set volume thresholds must carry out supply-chain due diligence aligned with the OECD guidance.
  • US Dodd-Frank §1502 — SEC-listed companies report annually on whether 3TG in their products may originate in the DRC or adjoining countries.
  • OECD Due Diligence Guidance for Responsible Supply Chains of Minerals from Conflict-Affected and High-Risk Areas — the common reference for both, built around five steps.
  • ICGLR Regional Certification Mechanism — the Great Lakes region’s own certification for 3T and gold exports.

Why 2026 raised the stakes

In June 2026 Global Witness published an investigation into coltan from the Rubaya area of eastern DRC, which has been under the control of the M23 armed group. It alleged that this material was laundered through Rwanda’s traceability system and reached global electronics supply chains. Several downstream companies were asked to respond. Whatever the outcome of those responses, the signal to buyers is clear: a tag or certificate is evidence, not proof.

The OECD five steps, applied to coltan

StepWhat it means on the ground
1. Strong management systemsA written supply-chain policy (OECD Annex II), named responsibility, and a chain-of-custody system that records every hand-off.
2. Identify and assess riskMap the chain back to mine sites. Check production capacity against volumes, transport routes, security presence and taxation by non-state actors.
3. Respond to riskMitigate, suspend or disengage according to the risk found. Escalate where there are signs of support to armed groups.
4. Independent auditRely on smelters and refiners that are independently audited, e.g. under RMI’s RMAP.
5. ReportPublish due diligence findings annually.

Red flags we act on

  • Volumes inconsistent with known mine or trader capacity.
  • Material transiting a neighbouring country that has limited production of its own.
  • Documentation that appears only after the material leaves the mine site.
  • Any payment — tax, “protection” or transport fee — to armed groups or unlawful security forces.

Beyond the Kivus

Responsible tantalum supply is not only an eastern-DRC question. Ethiopia’s Kenticha deposit and Mozambique’s tantalum production offer alternative sources, while validated sites elsewhere in the DRC provide traceable material. A diversified supply plan reduces the pressure to accept marginal lots.

Our approachWe trace to the mine, cross-check volumes and routes, verify licences directly with authorities and commission independent assays and site visits for any lot we broker. If a red flag cannot be cleared, the deal does not proceed.
Book a consultation